This application is a " iPhone connection type dosimeters: It is only for Geiger FUKUSHIMA." Even if it connects other dosimeters, it does not operate normally.

The feature:
1.Two kinds of measured value are displayed.(Upper part: microSv/h,lower part:CPM)
2.A design can be changed by acting as Flick of the screen.(13 screens)
3.Measurement range is 0.04-120microSv/h.(Survey by iPhone4S)

Directions for use:
1.Connect Geiger FUKUSHIMA and iPhone (or iPod touch) by an exclusive cable.
2.Start application.
3.A "wait icon" is displayed on an upper row display part after starting. It is in a measurement setup state in the meantime.
4.It is a measurement start when a "wave icon" is displayed on an upper row display part.
5.If a signal is received from Geiger FUKUSHIMA, the level gauge of a display part will react.

Supplement:
1.The cable should use the exclusive cable attached to a main part at any cost.
2.Measured value has adopted the "Moving average cost method."
Please carry out the RESET button, when you change the point of measurement.
3.Measurement will be interrupted if it goes into a sleep mode.
Please set up a sleep mode, when you measure for a long time.
4.When a big change arises in a dose of radiation, a "wait icon" is displayed and it will be in a measurement setup state.
5.Please Perform Judgment of Measured Value in Person.